Soldering station hotair and tip-based WEP 992D with fan in iron - 700W

WEP 992D soldering station with hot air iron and tip-based soldering iron with a capacity of 75 W. The device is equipped with a PID microcontroller unit, which checks the performance and adjusts it to the preset values.

• The operation of the hot air in automatic and manual mode:
  • automatic- when you put down the iron, the system will turn off the heat and cool down the iron to a safe temperature
  • manual- when you put down the iron, the system further heats a heating element. Before finishing, it is recommend you go to auto mode.
• The function of temperature correction depending on external parameters
• Mode C/Fthe ability to change the units in which temperature is displayed.
• Sleep function of soldering iron- if the iron is not used the given time interval (0 - 99 minutes) the system switches to sleep mode, that is cooled to a temperature of 200 °C, which ensures long service life of the device.

• Voltage: 220 - 240 V / 50 Hz (network)
• Power consumption: 700 W
• The station is controlled through a microcontroller that provides high stability
• The device has a PID controller
• Compact design with large and clear LCD display

• Soldering Iron Hotair:
  • The flow of air through the fan in the iron
  • Air flow: up to 120 l/min
  • Smooth adjustment of temperature in the range
  • Adjustable temperature hot air from 100 °C to 480 °C
  • Temperature stability: +/-1 °C
  • LCD display showing actual power supply
  • Operation mode manual / automatic
  • Protection before reaching the high temperature and inform the alarm
  • Cable length of the iron: up to 90 cm

• Soldering Iron Tip-based
  • Adjustment of the soldering tip temperature: 100 °C-480 °C
  • Temperature stability: +/- 1 °C
  • Peak power soldering iron: from 72 to 75 W
  • The resistance to grounding: up to 2 Ω
  • Capacity in relation to protective earth: up to 2 mV
  • The system is ESD safe
  • Cable length of the iron: up to 120 cm
  • Sleep mode: enabled after idle operation 0-99 minutes

• Station WEP 992D
• Stand for hotair iron
• Set of nozzles:
  • round with a diameter of 4.4 mm
  • round with a diameter of 7 mm
  • round with a diameter of 9 mm
  • square 12x12 mm
• Stand for the soldering iron with a cleaning sponge
• Soldering iron 907I with T-I tip
• A gripper for lifting circuits
• Power cable

First run

• You should not run the device immediately after delivery.
• Equipment must remain for about 12 hours at room temperature before switching on.
• All complaints caused by running of the equipment too soon will be denied.

• soldering tin of various diameters
• fluxes and rosins
• braids to remove excess tin
• suckers
• soldering tips
• tweezers,holders, magnifying glass
• sponges and cleaners