Soldering station 3in1 hotair and tip-based + power supply 15V/1A WEP 853DA

Station 853DA is the combination of hot air iron, tip-based soldering iron and power supply 15V/1A. The device has a smooth adjustment of power and temperature of the airflow and temperature adjustment of the tip with the buttons. The parameters are displayed on LED displays.

The station is controlled with a microcontroller, it has a cooling system of the heaterbefore shutting down and remembers the set temperature. It allows reading the real temperature of the hot air. All of the five modules can work independently.

• Supply voltage: 230 V / 50 Hz (network)
• Power consumption: 800 W
• The station is controlled through a microcontroller that provides high stability
• The station has read the real temperature value of hot air
• Compact design with LED displays
• Dimensions: 185 x 175 x 25 mm
• The weight: 4.2 kg

• Soldering Iron Hotair:
  • Blowing air through the compressor inside the station
  • Adjustable temperature hot air in the range: 100 to 480 °C
  • Temperature stability: +/-1 °C
  • Temperature setting buttons,
  • Maximum air capacity up to 24 litres/minute
  • The real temperature value of hot air
  • Adjustable air supply with regulator

• Soldering Iron Tip-based
  • Adjustable temperature soldering tip: 200°Cto 480 °C
  • Temperature stability: +/- 2 °C
  • Soldering iron power: 50 W
  • The resistance to grounding: up to 2 Ω
  • Potential relative to ground: 2 m

• Power supply
  • Output voltage: DC 0 - 15V
  • Maximum current: 1 A
  • Digital LED display

• Station WEP 853DA
• Stand for the hotair iron
• Set of nozzles:
  • round 2.5 mm
  • round with a diameter of 4.4 mm
  • round with a diameter of 7 mm
  • round with a diameter of 9 mm
• Stand for a tip-based iron along with a cleaning sponge
• Soldering iron witha T-I tip
• A gripper for lifting circuits
• Power cable

First run

• You should not run the device immediately after delivery.
• Equipment must remain for about 12 hours at room temperature before switching on.
• All complaints caused by running of the equipment too soon will be denied.
• You must completely remove the screw/screws from the bottom station if the source of air supply is the compressor. These screws are marked in red (1 or 3 screws depending on model).

• soldering tin of various diameters
• fluxes and rosins
• braids to remove excess tin
• suckers
• soldering tips
• tweezers, holders, magnifying glass
• sponges and cleaners