ACHS-7123 Current Sensor Carrier -30A to +30A - Pololu 4032

The sensor is based on Hall effect, itis suitable to use in 5 V systems. The minimum sensor's supply voltage is 4.5 V, maximum - 5.5 V.

• The system was designed for the current flowing in both directions (from -30 to 30 A), in our offer available are alsoother versions.
• A small losses of power
  • low resistance of the conductive path (0,7mΩ)
  • the PCB is made of copper with a thickness of 70µm
• The current paths are isolated from a current path
  • The possibility to install anywhere
• Work in a wide temperature range from-40 °C to 110 °C
• Accuracy at room temperature: 1,5 %
• Bandwidth of up to 80 kHz (reduction by using the appropriate capacitor)

The sensor requires connecting of a voltage supply from 4.5 V to 5.5 V over the fields VCC and GND. The output is analog voltage proportional to measured current (66 mV/A, centered at 2.5 V).

• Input current (IP+ and IP-)
• The logical power (VCCandGND)
• Sensor's output (OUT)

FILTER pin allows youto configure the bandwidthof the board by adding a capacitorCFto ground in parallel with a capacitor of 1 nF. Without the additional filter capacitor, the transmission bandwidth is 80 kHz. More information about the impact of the external capacitor of the filter on the bandwidth, is inthe catalogue's note.

Diagram with dimensions is availablehere(PDF)

• Supply voltage: 4.5 V to 5.5 V
• Suitable to use in 5 V systems
• Sensitivity of power supply: 0,066 V/A
• Supply current: 15 mA
• Dimensions: 17,8 x 20,3 mm

• The website of the manufacturer Pololu #4023
• Catalogue note
• Diagram with dimensions